4 Connect hard drive connector cable to logic board and install screw. 3 Attach hard drive connector cable to drive, and tilt hard drive into computer. 2 Make sure 4 rubber grommets are seated in top case before installing the hard drive. Replacement 1 Touch a metal surface inside computer to discharge static electricity.

Do not press drive between your fingers.Note: The top of the hard drive bracket has a long EMI gasket, not shown. Remove hard drive bracket and put it aside. 6 Loosen, but do not remove, 2 screws from the hard drive bracket. Note: In the center and at each side are 3 clips that attach to snaps on the top case. Replacement Note: Install screws in the ordĥ Tilt up and remove bottom case. Important: The screws at the sides and front of the computer must be removed and installed at an angle. Caution: To prevent scratches to the case, use a protective cloth when working with metal tools. 3 Put on ESD strap or touch metal to discharge electricity. Apple is not responsible for any lost data.

Removal Important: Make sure data is backed up before removing the hard drive. Although your model may look slightly different from the one shown in the illustrations, the steps ar Note: This procedure is for MacBook (13-inch, Late 2009) and MacBook (13-inch, Mid 2010) models. Failure to follow these instructions could damage your equipment and void its warranty.  MacBook (13-inch, Late 2009)/(13-inch, Mid 2010) Hard Drive Replacement Instructions Follow the instructions in this document carefully.

2008 macbook hard drive replacement